Density altitude: what it is, how to work it out and why it matters

Updated 17 October 2026

Density altitude is the altitude in the standard atmosphere at which the air would be as thin as it is around you now. The engine, the propeller and the wing all perform as if you were at that altitude. On a hot day at an aerodrome near sea level, your aircraft can behave as if it were taking off 2,000 or 3,000 ft higher.

Step 1: pressure altitude

Pressure altitude is the altitude on the altimeter with 1013 hPa set. From the QNH: pressure altitude = elevation + (1013 − QNH) × 30 ft. Thirty feet per hectopascal is the usual rule of thumb; near sea level it is closer to 27 or 28. On the ground, simply set 1013 and read the altimeter.

Step 2: the standard temperature

In the ISA it is 15 °C at sea level, falling by 2 °C per 1,000 ft. At 2,000 ft pressure altitude the standard temperature is 11 °C.

Step 3: density altitude

Density altitude ≈ pressure altitude + 120 ft for every degree the outside air temperature is above standard (minus 120 ft per degree below).

A worked example

Toussus-le-Noble (LFPN), elevation 538 ft, on a summer afternoon: QNH 1003 hPa, temperature 30 °C.

  • Pressure altitude: 538 + (1013 − 1003) × 30 = 838 ft.
  • Standard temperature at 838 ft: 15 − 1.7 = 13.3 °C. The day is 16.7 °C warmer.
  • Density altitude: 838 + 16.7 × 120 ≈ 2,840 ft.

The aircraft will take off and climb as if from an aerodrome at about 2,840 ft, not 538 ft.

Why it matters

In thinner air a normally aspirated engine makes less power, the propeller gives less thrust, and the wing needs a higher true airspeed for the same indicated airspeed. The take-off run gets longer, the climb shallower, and the landing roll longer too.

How much longer?

Always use the performance charts in your flight manual. Most light-aircraft charts ask for the pressure altitude and the outside air temperature and account for the density themselves, so enter those, not the density altitude. Rule-of-thumb factors widely taught in Europe, for example in the UK CAA’s Safety Sense leaflet on aeroplane performance, give an idea of the effect on the take-off distance:

  • +10% for each 1,000 ft of aerodrome pressure altitude;
  • +10% for each 10 °C of temperature increase;
  • +20% on dry grass, +30% on wet grass;
  • +10% for a 2% uphill slope;
  • +20% for a tailwind of 10% of the lift-off speed.

The factors multiply, and the leaflet recommends adding a safety factor of 1.33 to the take-off distance on top.

Questions pilots ask

Is density altitude the same as pressure altitude?

Only when the temperature is standard. On a warm day density altitude is higher than pressure altitude, on a cold day lower.

Do I enter density altitude into the flight manual charts?

Usually not. Most light-aircraft charts ask for pressure altitude and outside air temperature and allow for the density themselves.

Does humidity matter?

A little. Moist air is slightly less dense than dry air, so on a hot, humid day the aircraft performs a bit worse than the formula suggests.

A study and planning aid. The AFM/POH, your national AIP and the current EASA regulations always take precedence.